Farmall & IHC Tractors Discussion Board |
Bush hog
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dachshund on April 17, 2002 at 16:24:25 from (162.40.80.181):
My brother has a JD brush hog mower (#509 I think) that has the disc clutch in front of the head. The clutch is in several pieces, and a mixture of old / new plates. It is nothing but a royal pain! The thing is so messed up that it won't even allow the shaft to turn (slips so bad and won't tighten up at all). We want to know if it is a good idea if we remove or weld the clutch solid if an overun is used on the PTO on the 460. Any ideas? the mower cost him $75 about 4 years ago and started this deal this year. Don't want to put a lot of $$$ into the thing.
Follow Ups:
Home
| Forums
Today's Featured Article -
Restoration Story: 1951 Farmall H - by The Red (John Fritz). I have been a collector of Farmall tractors since 1990 when I first obtained part of the family farm in Eastern Indiana. My current collection includes a 1938 F20, 1945 H, 1946 H, and the recently purchased 1951 H. This article will focus on what I encountered and what I did to bring the 1951 NEAR DEATH Farmall H back to life.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|