Farmall & IHC Tractors Discussion Board |
I dropped it in the dirt
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Scott A on April 28, 2002 at 04:10:28 from (206.243.130.85):
I found the small screw for the Farmall A fan pulley, removed it gingerly, was holding on to it in the swirling snow this morning, and as I pulled my hand out, I bumped it on the governor or fan shroud and my screw for the pulley dropped, clinked on some metal, and it's nowhere to be found in fresh turned loam and dirt. I tried. What size of screw is it that I need to replace on the fan pulley for a Farmall A? It is the screw to remoe and put oil into the fan pulley. Does anyone have a parts manual handy to give me the screw threading specification, size and length? I may find it at the hardware store. Scott A
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers WD45 (Gas Version) - by Staff. Beginning production in 1953, the WD45 had the same general look as the WD tractor which was produced earlier - but was much more powerful. This was due to the new 4-cylinder "Power Crater" gasoline engine with a 4 x 4-1/2 inch bore and stroke. Some people feel this was one of the most significant tractors offered by Allis-Chalmers in those days. Nothing in its weight or power class could match its performance. In 1954 they began offering the WD45 with the new "Snap-Coupler&quo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|