|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: 1066 wheels
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Craig MO on April 28, 2002 at 17:36:30 from (216.139.97.104):
In Reply to: Re: Re: Re: 1066 wheels posted by Kevin-IN on April 28, 2002 at 04:47:18:
If you loosen the wedge bolt but do not unscrew it out of inner wedge jack tractor up until wheel is off ground. Turn wheel until the two flat spots on axle are on top. Hit the top side of axle out towards the end of the axle with a maul. I use a 12# one and about 5 or 6 hits and most usually come loose. If its real tough it may take 15 or 20. This is the procedure that I was told to do and I've done a bunch and it works.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Fordson F Ignition System - by Anthony West. A fellow restorer contacted me earlier this year asking for some help and advice on a model F that he was restoring. He had over a period of months spent a fair amount of his hard earned cash on replacement parts for the old "trembler" ignition. Sadly though all his efforts seemed to be a waste of time and money as he still couldn''t get the temperamental old thing to run correctly!! If i said that this was a little frustrating for him that would be "conservative" in fact the problem had reduce
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
