|
Farmall & IHC Tractors Discussion Board |
Super A-bad noise?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by JohnK on April 29, 2002 at 09:34:30 from (143.206.70.73):
On my Super A, sometimes when I am just driving it arround fairly slowly I hear a clunk or heavy click that seems to originate either in the transmission or, more likely, in the left final drive. I checked to see if my rim bolts and lug screws are tight and they are. When I run the tractor wide open, operating the belly mower, I don't detect any such noise. It could just be drowned out, but I think it actually goes away because I don't feel anything of the sort either. I opened up the plate on the final drive where one might attach a side dresser pto and I noticed that where the inside bull gear bearing fits the casting it is somewhat worn so that the outer race doesn't fit tight. Could that be the cause? Does anyone out there have a similar experience? Could I tap in a shim and tighten things up? Many thanks to the guys with experience. This board is a tremendous resource!
Follow Ups:
Home
| Forums
Today's Featured Article -
Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
