Re: Removal of F20 Flywheel

Posted by LynMn on May 07, 2002 at 17:03:11 from (209.23.148.72):

In Reply to: Removal of F20 Flywheel posted by Ryan Brown on May 07, 2002 at 09:03:39:

The theaded key you see is a taper pin with
about 5/16 or 3/8 sae.thread. Do Not attempt to
pull this pin. Use a cut away washer and a short
bolt,snug it up and pull key along with f/wheel.
The wheel is on a straight shaft and will need
pulling all the way.Some pulled very hard,others
not bad. We had a special puller-pusher by O.T.C.
that did the job. Maybe an older I.H. dealer
would still have one, under the bench or in the back room.

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: Removal of F20 Flywheel Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]