|
Farmall & IHC Tractors Discussion Board |
Re: PTO gasket
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jon with an M on May 10, 2002 at 05:05:11 from (158.114.92.201):
In Reply to: PTO gasket posted by chuck on May 09, 2002 at 20:22:32:
On my 41 M 3 bolts hold the seal housing in place and 5 bolts hold the whole PTO on. The old seals are about an inch thick, the new ones are about 1/4 inch thick and they are cheep so I put 2 in there. If you are going to pull the PTO out you will need to drain the trans/rear housing. There should be about 16 gallons of gear lube in there but probably less if it has been leaking and I always find water and goopy glop ( technical term for 60 years of water, dirt, metal and oil ) in there. with the PTO out you can get your whole arm in and realy clean it out. Enjoy
Jon
Follow Ups:
Home
| Forums
Today's Featured Article -
Pitfalls of Tractor Engine Rebuilds - by Chris Pratt. The first pop after you have put the machine together with your own hands is exciting and pleasing. The whole experience can be marred if one moves too fast and makes too many assumptions that they can just use "as is" some parts they should be closely scrutinizing and possibly attended to. In such cases, rework makes what could have been a fun project turn into an irritant or even a nightmare. Minor Irritants To give you an example of an minor but irritating proble
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
