Farmall & IHC Tractors Discussion Board |
Re: Firecrater pistons
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RPM on May 13, 2002 at 05:55:22 from (63.110.182.225):
In Reply to: Firecrater pistons posted by Ron on May 11, 2002 at 20:10:21:
They were sold by IH, mostly parts counter, last 300/350/400/450 were the only ones that actually came out with them, IH made them for for overhauls to replace the flat top standard pistons, It was a copyright name for IH, the drawback was hard starting and required good gas to get them to run right, this was in the days of a lot of plowing & disking, in our dealer shop we had 3 mechanics overhaul M/SM/400/450/560 all winter, thats all they did. Timing was critical, they sent carb & dist parts in the box with the sleeves & pistons.
Follow Ups:
Home
| Forums
Today's Featured Article -
Uncle Cecil's Super A Lives Again - by Mike Purcell. A week or so out of most of my childhood summers was often spent with my Uncle Cecil and Aunt Sissie in the small East Texas town of Maydelle on their 80 acre farm. Some of my fondest memories of these visits are those of learning to drive a tractor at the helm of Uncle Cecil’s 1948 Farmall Super A. Uncle Cecil was the second owner of this wonderful little tractor, but it was almost as though he had adopted an infant. The original owner was a man from Minnesota who bought her from a local dea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|