Re: Required Tools - (Must haves?)

Posted by the tractor vet on May 17, 2002 at 09:18:57 from (216.196.13.66):

In Reply to: Required Tools - (Must haves?) posted by Mitch - MS on May 17, 2002 at 08:59:17:

Well to start a good set of splitting stand , a real good cherry picker of at least 2 ton cap. a real good floor jack of at least three ton cap. Then there tools that you can not get unless you happen to buy out and old IH dealer like i did, you can have a machine shop make seal drivers that are needed or yo can screw up a half dozen of them tryen to in stall and you must have the rear crank seal installer to install that one and get it rite then there is the set up tool to set the ring and pinion depth, and the special socket for the lower contershaft and the tool to remove the Quill and t/a assy. and the list goes on but you get the idea.

Follow Ups:

• Re: Re: Required Tools - (Must haves?) Mitch - MS 10:12:56 05/17/02 (1)
  • Re: Re: Re: Required Tools - (Must haves?) the tractor vet 10:46:36 05/17/02 (0)

Post A Followup Name: E-Mail: Subject: Re: Re: Required Tools - (Must haves?) Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]