Farmall & IHC Tractors Discussion Board |
Re: M clutch issues...again
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Charlie on May 17, 2002 at 14:21:39 from (66.133.134.173):
In Reply to: M clutch issues...again posted by Dave from MN on May 17, 2002 at 08:16:58:
I mention this because I screwed up once and had it happen to me - I had my clutch plate get wrarped one time after I changed the rear crank shaft seal and tried to reinstall the engine with the clutch still in the tractor. The tractor acted the same way you are describing now. You will have to take the clutch back out to check but if you do, place a straight edge across it the best you can (center gets in the way). If it doesn't touch the straight edge all the way across its wrarped. The fix is a replacement.
Follow Ups:
Home
| Forums
Today's Featured Article -
Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
Latest Ad:
1997 cub cadet 7275 compact utility tractor 4wd hydro trans cracked block 3500
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|