|
Farmall & IHC Tractors Discussion Board |
Steve Mason ---- hand crank
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by jtwaldo on May 20, 2002 at 10:39:50 from (199.79.251.179):
Here is what I got when I measured my hand crank for the 200. ignore the periods. the html ignors spaces so i have to put something there to draw the picture. .. the steel rod is 3/4" in diameter. .. It is 17 1/2" long. .. Bends down 90 degrees it goes down 8 1/2". .. Bends bends 90 degrees again and goes straight
...for 5" .. 3/4" from the end (on the 17 1/2" part) there
is a 3/8" rod that goes through the 3/4" rod.
it sticks out about 3/8" on either side of the
3/4" rod (sorry forgot to measure this but
that should be right). ..........17 1/2"
....-----------------
..............................|
..............................|8 1/2"
..............................|
...............................------- 5"
..3/8" diameter rod sticking out 3/8"
........ on either side
.......|.|
..---|.|----------- 3/4" diameter rod
..---|.|-----------
.......|.|
3/8" rod 3/4" back from end hope this helps
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - Tractor Engine Repair - by Teri Burkholder. One of the great things about working on a tractor engine with your other half is that you know what he is thinking of at all times and can anticipate his every move and his next thought of what he will do. With Ben, anyway, I can tell! He'll be busy working and I’m handing him tools and he says, "give me that..." and I’ve already got it in his hand or "hand me that....."and I’ve got the portable light right where he needed it placed to see. "Run in the house and get me a...."as I open th
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
