Farmall & IHC Tractors Discussion Board |
Thanks for the info
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by jtwaldo on May 27, 2002 at 09:50:07 from (199.79.251.51):
Just wanted to say thanks for the info on the generator. I have the generator back now. The new belt I have happens to be one of the notched v belts. I left it loose enough so that i can spin the pulley on the generator by hand. I figure that there is no way the belt is putting any tension on the shaft now. I may have a bad gauge. It does have a crack in the lens. The needle at idle is sort of "unstable". if you give it some more throttle, it settles on the mark between the O and C. The battery (which is new) is pretty much dead. It seems to be charging it I just haven't had the time to run it long enough to get a good charge on it. Just wanted to give ya'll (i am from South Carolina) an update and say thanks for the info.
Follow Ups:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|