Farmall & IHC Tractors Discussion Board |
Farmall H tranny seals
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ray A on June 10, 2002 at 16:38:11 from (66.64.31.146):
Looking at the H today and tranny oil was dripping from inspection plate just rearward of Liftall pump. I took off the cover and it appears that the seals are leaking where the driveline goes into the tranny and then also the seal below that where the Liftall drive exits the tranny and back to the pump. I went to the Case dealership today and he said that he couldnt get them anymore. Does anyone out there have the numbers for these seals (IH #'s would work so I could cross over). Saw a similar post to this about a week or so ago, but cant find it now. Also, Anyone ever replace felt gasket for inspection plate, and where to get it. Thanks in advance. RAy A
Follow Ups:
Home
| Forums
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|