Farmall & IHC Tractors Discussion Board |
Why is it doing that? 706 question.
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by C Kulig on June 14, 2002 at 06:34:32 from (64.33.178.231):
I have a 706 gas with the 291 in it. It's dripping engine oil out the breather tube. Alot of oil. but only at wide open under load. It has next to no blow-by even at wide open throttle under no load. I had the side cover off and tried dumping diesel down the returns thinking they could be plugged, it drained away as fast as i could dump it in.(yes I changed the oil after that)I bought this tractor with a bad valve, so I had the head off for a valve job. Cylinder walls look great. I can still see the marks from when it was honed. tractor runs good and has good power. I just can't have it leaking all this oil. Any sugestions? Thanks, Chad
Follow Ups:
Home
| Forums
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|