Farmall & IHC Tractors Discussion Board |
856 help needed.
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Wes Taylor on June 14, 2002 at 21:08:30 from (216.40.221.55):
I just bought a 856 disel, it worked good when I tried it out. After getting home and working some, with a 10 pt chisel plow, when TA is engaged it hesitates before TA engages (4-5 secs). Also, in H4, clutch seems to slip for same amount of time then engages and takes off(in direct drive or TA). Is there a mechanical adjustment, hydraulic vavle sticking, or is TA shot? Have I just jumped into a money pit? TAHANKS FOR HELP!!!
Follow Ups:
Home
| Forums
Today's Featured Article -
The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|