|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Re: Re: Farmall 300 shifting problem
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by rich on June 16, 2002 at 20:10:17 from (206.9.239.132):
In Reply to: Re: Re: Re: Re: Re: Farmall 300 shifting problem posted by DLW on June 23, 1999 at 03:38:25:
yes the ta must be engaged in low . when properly adjusted the footclutch will automatically put the ta in low range. that is because the overrunning clutch in the ta prevents the ta unit from spinning backwards.This ta unit in direct drive(high range) acts like a driveshaft but cannot spin backwards. in ta (low range) the power goes through 3 plenetaries and the power going through the plenetaries can go backwards and allows a shift to take place. if the ta carrier could spin backwards then the tractor will stop when the ta is pulled back. You may have more than an adjustment to do.
Follow Ups:
Home
| Forums
Today's Featured Article -
Pitfalls of Tractor Engine Rebuilds - by Chris Pratt. The first pop after you have put the machine together with your own hands is exciting and pleasing. The whole experience can be marred if one moves too fast and makes too many assumptions that they can just use "as is" some parts they should be closely scrutinizing and possibly attended to. In such cases, rework makes what could have been a fun project turn into an irritant or even a nightmare. Minor Irritants To give you an example of an minor but irritating proble
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
