|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: M Timing Marks.....Double Punch on Crank?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob M w/pix on June 26, 2002 at 16:29:23 from (24.169.120.138):
In Reply to: Re: Re: M Timing Marks.....Double Punch on Crank? posted by Mr. J on June 26, 2002 at 10:05:14:
Jared - If memory serves (it's been a couple years now...) the crank gear timing mark was a double punch on a crank gear tooth. I don't recall seeing any another mark on mine. Easy way to verify would be to remove the #1 spark plug, then have an assistant turn the crank while you peer in the #1 plug hole. Stop turning the crank when see the piston crown reach TDC. The crank gear timing mark will be the mark at the mesh point with the cam gear. Punch below for a few pix I took when I had mine apart...
Follow Ups:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
