Farmall & IHC Tractors Discussion Board |
'49 Cub wiring diagram
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jimmy Burcher on July 02, 2002 at 08:39:52 from (206.107.254.41):
I have a student who just completed the overhaul of his grandfather's '49 Cub in our school shop. Some of the wiring had been switched over the years and we are having a hard time helping him correct wiring problems. Local IH dealer was able to provide the generic diagrams from their manuals, but their diagrams show a 3-lug regulator mounted on the top of the magneto. This tractor has a 3 lug cutout relay (I think) on top of the generator. All wiring is original 6 volt and we hope to keep it that way. Light switch is a 4 position switch. Would anyone have a copy of a schematic wiring diagram that you can help us out with? So far the archives haven't been of much help on this model. Thanks
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|