Farmall & IHC Tractors Discussion Board |
Re: Considering a BN
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by check out an A in the classifieds of this site on July 09, 2002 at 13:43:18 from (206.243.130.219):
In Reply to: Considering a BN posted by Steve W on July 09, 2002 at 06:29:57:
BN parts and implements are hard to come by. I have a good memory and but is short sometimes and I am trying to recall what Guy Fay wrote in his new book. I carry that book with me everyhere and study it. But my wife has it in her car right now. Yes, BN's are somewhat more rare than A's and B's. They were considered a specialty type of tractor for farmers with specific needs not needing two row cultivation capability of the B and narrower rows than a B. You can always swap over and stick a B rear end on the BN to use more implements from B's. But why? Just get a B. You have more variability to slide the axles in and out on a BN. The width of the BN is 47 3/8"between the two faces of pads for the drawbar. Minimum tread width is 56" and maximum tread width is 84". Whereas the B had a width of 55 3/8 between the faces of the drawbar pads and minumum tread width of 64" to maximum tread width of 92" Now for the A: Offset engine for visibility. Dimension between the faces of pads for the drawbar is 29 3/8" Minimum tire width is 40" and maximum tire width is 68". There is a Farmall A in New Hampshire that is advertised in the classifieds of this site. I have seen it, and it is really beautiful and runs really good. Consider it as a nice tractor to get. tom
Follow Ups:
Home
| Forums
Today's Featured Article -
The Day Tractor Lovers Dream About - by Angus Crawford. The day started at five o'clock on the morning of Friday, the January 29, 1999. My father, my sister, my uncle, my cousin and myself all climbed into my uncle's Toyota van. It was six thirty in the morning and we had a long day ahead. We traveled for six and a half hours to our destination - a little country town with a population of no more then one hundred and fifty people (57 of them being children under the age of thirteen). We arrived hoping to meet up with a man we knew had over one
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|