|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Magneto impulse help, please!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Farmer Gene (WI) on July 21, 2002 at 03:02:08 from (64.91.86.61):
In Reply to: Re: Re: Magneto impulse help, please! posted by Mike Schotte (What's the point gap?) on July 20, 2002 at 15:04:46:
Mike, lets back up and try this again, first you took the nut off, the disc your trying to remove is the one with the two ears on it right? the spring will be between it and the next disc. I looked at one I got in the shed and the disc slid right off shouldn't need a puller. Now if your trying to get the last disc off I would assume that it is keyed on, but there should be no reason to take it off unless you need to replace a bearing. Point gap is .013 Hope you can make some sense out of this. Gene
Follow Ups:
Home
| Forums
Today's Featured Article -
The Fordson F Ignition System - by Anthony West. A fellow restorer contacted me earlier this year asking for some help and advice on a model F that he was restoring. He had over a period of months spent a fair amount of his hard earned cash on replacement parts for the old "trembler" ignition. Sadly though all his efforts seemed to be a waste of time and money as he still couldn''t get the temperamental old thing to run correctly!! If i said that this was a little frustrating for him that would be "conservative" in fact the problem had reduce
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
