Farmall & IHC Tractors Discussion Board |
Re: Farmall A differences???
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by CraigMN on July 27, 2002 at 20:06:02 from (209.131.236.33):
In Reply to: Farmall A differences??? posted by Bjorn on July 26, 2002 at 20:58:45:
Yep, the larger PTO shaft is to meet ASAE standards. You can install a 1-3/8" PTO shaft in the tractor with the smaller one. Somewhere early in the life of the A Farmall there was a part number change of the PTO casting and maybe the belt pulley casting. Maybe your tractors cross that serial number change???? My 1942 A has the small shaft (and the later casting numbers) but I have a large shaft to install in it soon. IH offered a kit to change from the 1-1/8" PTO shaft to the 1-3/8" shaft. That kit might have included the adaptor plate (in addition to the PTO shaft) that I see on some A and B farmall tractors but I don't know for sure.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|