|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: ATTN: F14
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Brian W. on August 02, 2002 at 07:14:58 from (152.163.189.203):
In Reply to: Re: Re: ATTN: F14 posted by MikeH-Tx on August 01, 2002 at 19:18:44:
Ok thanks for all the relpies.....All new fuel lines, small inline filter just in case. Fuel pump has been rebuilt, Vent in top of hood is clear, gas cap also drilled and usually left a little loose to help prevent vacuum in the tank. messed with mag timing more than I care to admit to!! Gonna think about sending carb in and exchange it for a completely rebuilt one... Also thanks to all that answer, I have given some advise to others on this board before but by far have asked more questions and truly appreciate those that answer. Also love Rice Equip. they have quite a few of my dollars (or as my wife says her money!!HAHA)
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
