Farmall & IHC Tractors Discussion Board |
H starter problem
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Farmall ED on August 11, 2002 at 10:22:31 from (209.240.198.63):
Sometime back the starter on my H would not engage.I just took it apart a couple of days ago and this is what I found,the round collar nut on the front end of the starter drive was off,this is the nut that has a recess on the back side to allow the spring in front of the drive to compress.The spacers were gone that prevents this nut from contacting the front housing when the starter is activated.I believe the 12 volt power must have been enough to knock the nut off with the spacers missing,also the threads and the end of the shaft were damaged.I put it all back together and my son in law welded it in four places,I smoothed it up with the grinder and put it back on,works great now ,started the tractor six times and ran the starter with switch off sounds good.Oh yes the spacers are there now! Sorry for the long post but it might save buying a new bendix which are rather expensive.Thanks ED
Follow Ups:
Home
| Forums
Today's Featured Article -
The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|