|
Farmall & IHC Tractors Discussion Board |
Re: Re: IH loader
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dale on August 14, 2002 at 13:11:13 from (134.84.43.16):
In Reply to: Re: IH loader posted by Farmer Bob on August 14, 2002 at 08:29:26:
Farmer Bob, I assume the drive coupler shaft is inside and under the tractor? Where do I look and what should I see? I have an IT manual, will look at it tonight. The hoses jump a little and the cylinders came out about 3 inches. And there's pressure in the system - oil spews out when I changed the left side hookup. When I shut off the engine, I could hear the air pressure coming from the screw cap on the top right side of the tractor, just above the outlet on the right. Thanks again. DH
Follow Ups:
Home
| Forums
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
