Flooding problems

Posted by Jeff S on August 17, 2002 at 18:33:06 from (209.176.194.186):

I have a 1946 H with a D-10 Carburator. I did a complete rebuild of the carb a few months ago using an IH rebuild kit. Now all of a sudden it it started flooding out. I have had the carb off about 4 times now (cleaning it each time), the needle and seat are clean and functioning properly, the float and axle (which were just replaced) are free and not filling up with gas, and the float is set at 1 27/32 (1.844) off of the gasket when the carb is split (measuring off of the upper half with it inverted upside down) as specified in the IH instructions. Yet, with it all re-assembled I'll hear gas dripping out of the drip hole to the garage floor on the first attempt to start it. It seems to immediately flood out. What else can I do to make this thing run?!!!!!

Follow Ups:

• Re: Flooding problems Ol Chief 20:25:23 08/17/02 (0)
• Re: Flooding problems Larry F 19:35:38 08/17/02 (0)

Post A Followup Name: E-Mail: Subject: Re: Flooding problems Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]