Farmall & IHC Tractors Discussion Board |
Re: International - A
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by BIG JOHN on August 20, 2002 at 19:29:36 from (64.12.97.13):
In Reply to: International - A posted by Mark R. on August 20, 2002 at 18:54:35:
Mark, for what it is worth, I bought one like you are describing only in worse condition two months ago. It was at a consignment sale. Both rear tires and rims were completely trash. Hood was bent down the middle like a lot of them are. Pneumatic lift was not complete and what was there was also trash. Lights were mostly missing. Engine was (and still is) stuck. Cooling system was tight and full of antifreeze. Front tires were flat but did hold air. Grill was mashed in. After I got it home and checked it over, the following is the assement. Will need new rear rims and tires and new front tires. Hood straightened and the grill will be acceptable after a lot of work. Fenders are straight. Seat is in good shape. Electrical wiring will need to be replaced along with all lights. Don't know yet about the generator, mag or starter yet. New battery is also on the list. No paint and lots of surface rust. Engine is still stuck after trying just about everything. No rust or water where it shouldn't be but I am sure it will require at the least a set of sleeves and pistons. Paid $325 for it and I still think it was cheep. I will have at least $400 in rear tires, tubes and rims. So $700 sounds good to me, GO FOR IT!!!!!
Follow Ups:
Home
| Forums
Today's Featured Article -
Fabrication (Who Me? Make it myself?) - by Chris Pratt. First of all, what are the reasons for not fabricatin your own parts? Most judgements on what should be purchased rather than fabricated stem from: Originality - If the tractor restoration is to be 100% original, it is likely that you should spend the time and money to locate the component in the used or New-old-stock market. Since this can be extremely difficult, you may want to fabricate the item or purchase a modern replacement temporarily, but eventually, you s
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|