Farmall & IHC Tractors Discussion Board |
Re: H farmall transmission gearing?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Haas on August 24, 2002 at 15:27:47 from (166.72.245.146):
In Reply to: H farmall transmission gearing? posted by Bill Smith on August 24, 2002 at 14:48:22:
As the others said, there was an optional 7 mph 4th gear for the H. You would need two gears to change it over and you would have to take both the main and countershaft out of the transmission to change them. You would need part 62396DA, Fourth and fifth speed sliding gear, 29 and 18 teeth, replacing one with 35 and 18 teeth. And, part 62395D third and fourth speed driving gear, 31 and 41 teeth, replacing one with 31 and 35 teeth. Don't know where you would ever find them though, unless you lucked up and found a salvage dealer that had a tractor so equipped and was parting it out.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
1997 cub cadet 7275 compact utility tractor 4wd hydro trans cracked block 3500
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|