Farmall & IHC Tractors Discussion Board |
Re: Can I
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by The Dukester on September 08, 2002 at 20:01:15 from (65.89.19.109):
In Reply to: Can I posted by SRJ on September 08, 2002 at 11:20:58:
No, an M with the wheels dished out is just too wide no matter what size tires are on it. My M with 13.6-38's is too wide for my trailer which is 83 1/2 inches wide inside the fenders. I load it front first and slide off the left rear wheel and turn it around(using a good 5 T. jack and blocks on level ground)then turn it back when I get to my destination. Tires aren't loaded and only one wheel weight is used so it isn't too bad a job, you learn to be very careful handling those wheels. This M weighs about 5400 lbs. which I haul quite easily on my 7000 lb. Carson trailer pulled by a F 250 Ford pickup. I hauled my John Deere GW from northern California to Michigan with this rig and had no trouble. The GW weighs 6100 lbs., I load it with about 400 lbs tongue weight, making sure the single axle electric brakes always work and your load is securely chained down. You must pay attention to your driving when driving any loaded rig and never allow yourself to "goof off". Never get in a hurry or take chances, and always be looking far ahead for things that might require you to stop.
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - Tractor Engine Repair - by Teri Burkholder. One of the great things about working on a tractor engine with your other half is that you know what he is thinking of at all times and can anticipate his every move and his next thought of what he will do. With Ben, anyway, I can tell! He'll be busy working and I’m handing him tools and he says, "give me that..." and I’ve already got it in his hand or "hand me that....."and I’ve got the portable light right where he needed it placed to see. "Run in the house and get me a...."as I open th
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|