|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Re: Valve adjustments on flathead Cub
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Don on September 11, 2002 at 05:07:40 from (168.166.51.12):
In Reply to: Re: Re: Re: Re: Valve adjustments on flathead Cub posted by Bus Driver on September 11, 2002 at 04:25:26:
Thanks a lot for the info. I seem to do a lot of engine work on my wife's car, but never have I done a flat head. I recently replaced the head in the car without any problems. Is there any way to up the horsepower in a Cub engine? When the grass gets tall it pulls really hard on that 59" mower deck in first gear. It takes a long time to mow about 4 acres. But my ground is too hilly to run the mower on the Super C with the tricycle gear.
Follow Ups:
Home
| Forums
Today's Featured Article -
A Tractor's Point of View - by John Manley. I began my life on August 3,1941. I was actually built at different times and days but I was officially an M Farmall on August 3.I was real nice and shiny. That’s me, in the old picture, third from the left. I was loaded on that train and sent to a little town in South Carolina. I didn’t get to see much of that town. I was moved off the train fast and on to the dealer’s
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
