Farmall & IHC Tractors Discussion Board |
Need advice on fine tuning Farmall 300 distributor by
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ray on September 21, 2002 at 18:14:30 from (205.138.22.81):
fine tuning the advance weight's springs. The reason I am looking for advice on this is because I'm only able to get a happy medium on power when adjusting the distributors timing. I have taken the distributor apart and checked everything and nothing seems unusally loose and all moving parts seems to be in good working condition. When I retard the timing on my 300 slightly, I gain more low end power while loosing a little power and rpm at top end. Then when I advance the timing on my 300 just a little, I loose some low end power while gaining power and rpm at the top end (and also causes the tractor to be a little harder starting). I feel that my springs on the advance weight's are not set right or are not operating at the right time do to too tight or loose tension. The springs feel strong and look original, But I was wondering if these springs should be set with a certain looseness or tightness on the holding pins. Currently I have both spring's set to where they just barely sit on the holding pin's without any tension on the springs by just bending the spring's loop ends. I feel there is more power potential in my 300 by fine tuning my distributor but maybe this is the way the tractor was originally set up. Any information, specifications, diagrams, best place to buy new springs, or suggestions that anyone has on the Farmall 300 distributor timing would be appreciated. Ray
Follow Ups:
Home
| Forums
Today's Featured Article -
Pitfalls of Tractor Engine Rebuilds - by Chris Pratt. The first pop after you have put the machine together with your own hands is exciting and pleasing. The whole experience can be marred if one moves too fast and makes too many assumptions that they can just use "as is" some parts they should be closely scrutinizing and possibly attended to. In such cases, rework makes what could have been a fun project turn into an irritant or even a nightmare. Minor Irritants To give you an example of an minor but irritating proble
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|