Farmall & IHC Tractors Discussion Board |
Re: Re: plow day pix
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob M on September 30, 2002 at 05:25:40 from (165.170.128.68):
In Reply to: Re: plow day pix posted by Red Dave on September 30, 2002 at 05:10:18:
Thanks Dave! That plow behind my Super M (incidentally the same plow seen behind the 400) is a 4 x 14" Oliver. We rescued it out of a fence row a few weeks ago where it had sat unused for 30+ years. Stuck on a fresh set of points, replaced a tire, hung on a cylinder and put it to work. Required a couple rounds to scrub the rust off the moldboards, but once clean it plowed pretty good. Pulled fine in 2nd gear. Nice to hear the old Farmall 4 cylinder doing real work once again!
Follow Ups:
Home
| Forums
Today's Featured Article -
Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|