Farmall & IHC Tractors Discussion Board |
Re: Thermostat Upside Down?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Harry on October 04, 2002 at 07:09:47 from (4.63.64.91):
In Reply to: Thermostat Upside Down? posted by Walt on October 03, 2002 at 05:26:11:
The "button" part of the thermostat goes in towards the motor. The button usually has the opening tempature of the thermostat stamped on it. The "cage" portion of the thremostat goes towards the radiator. The cage looks like 1/2 of the McDonalds arches, and has a small rod from the center of the thermostat that connects to the center of the arch. I also modify all of my thermostats with a "bleed hole". I drill a 1/8" hole in the flange (close to the center of it) so that a small amount of water is allowed to circulate past the thermostat when it is in the closed position. This also allows trapped air to be bled out of the system. The hole allows for a more accurate operation of the thermostat. All of the more expensive thermostats will have some type of hole, or bleeder valve built in them for this exact purpose. Good Luck Harry
Follow Ups:
Home
| Forums
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|