|
Farmall & IHC Tractors Discussion Board |
IH 424 oil light
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by GAF on October 17, 2002 at 17:20:44 from (216.175.44.107):
I'm looking at buying a 424 w/loader. Starts & sounds good, doesn't smoke. Shows only 1700 hrs. on the meter, but no way of knowing if it is the original tach/hr. meter One thing concerns me, the oil light continues to flash several minutes after it is started until the throttle is opened to 1200 rpm's. Keep it revved up & oil light stays out, idle it back down & oil light starts flashing. As I said motor sounds tight, doesn't knock, lots of power. I concerned that I could be looking at worn crank or bearings. If I were able to put a pressure gage on it what should the normal oil pressure be? Is there anything else hooked to the oil light besides the engine oil pressure? I seem to remember that on larger IH's it also monitored trans. oil pressure. Are there any problem areas w/ the 424 that I should be aware of? Parts availability?
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Earthmaster - by Staff. This tractor, manufactured by the Earthmaster Farm Equipment company in Burbank, California was made for only two years. The Model C came out in 1948 and was followed by the "CN" (narrow-width model), "CNH (narrow-width high-crop model), "CH" (high-crop), "D" and the "DH" (high-crop) in 1949. The main difference between the models was tire size, tractor width and cultivating height. The "D" series were about 20 inches wider overall than the
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
