Farmall & IHC Tractors Discussion Board |
Re: The Weakest Link...Is This Supposed To Happen?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on October 20, 2002 at 06:40:12 from (216.208.58.158):
In Reply to: The Weakest Link...Is This Supposed To Happen? posted by Salmoneye on October 20, 2002 at 04:28:21:
Sorry to hear and see your misfortune. Those straight arm loaders are awfully hard on tractors. One could say castings are old and metal fatigue has set in. My dad broke his H like this when it was 3 years old. Same thing, straight arm loader. Bolt were not loose on dad's H. The engineering was not great on these loaders. Newer loaders with sub frames beef up the tractor. Tractor really isn't the best engineered vehicle for a loader but we all use them, economics is the name of the game. Something you might look at, a good metal fabricator could incorperate a sub frame into that loader. All you need is heavy 6-8 inch chanel from rear axle housing to front bolster and anchored to clutch housing. My dad's H broke just ahead of pedals, thus steering wheel pinned his trousters to seat. Luckily, trousters was all it caught. He had to use pocket knife to free himself.
Follow Ups:
Home
| Forums
Today's Featured Article -
Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|