Farmall & IHC Tractors Discussion Board |
Re: Re: In search of the all around Farmall
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Big Mike on October 21, 2002 at 01:52:17 from (152.163.189.203):
In Reply to: Re: In search of the all around Farmall posted by Justin Ny on October 18, 2002 at 20:59:28:
I think Fords get a bad rapp from people who do not like them for being a Ford. True I will admit the 9n,2n,8n are a little tall geared from the factory . Aftermarket aux transmisions cure this if you can find one. Get yourself a later hundred series with a 5 speed trans they are geared right.I have an 850 that will work circles around an H for the type of work you asked about. If it was an 860 it would be better as they have a two stage clutch allowing you to stop tractor and keep the pto spinning. In my area Fords are plentiful and parts are very easy to get....Not against farmalls at all as we have 3 cubs and a super A also but for an all around work tractor the Ford suits me.........Big Mike
Follow Ups:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|