|
Farmall & IHC Tractors Discussion Board |
Got my dad's Super M running. Picture link
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob in SE Nebraska on October 23, 2002 at 18:56:29 from (162.40.71.186):
It has been a really good Farmall day for me. I just got the engine back together on a Super M that my dad had bought new. The tractor had been stuck and an attempt was made to free the engine by using hydraulic pressure applied through the spark plug hole into the cylinder. This method caused a very bent rod. It had been over ten years since the tractor ran so it was a real joy to hear it start and run again. I will finish installing pieces and run it until spring before I paint the tractor which will allow me time to find where all the leaks are and fix them before the paint job. Thanks for all the help from everyone on the forum. Bob
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
