|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Professionally restored M for only $11,500!!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by COWBOY on October 24, 2002 at 15:47:58 from (12.149.226.158):
In Reply to: Re: Re: Professionally restored M for only $11,500!! posted by Red Rider on October 24, 2002 at 14:49:13:
Yep,.. I'm Cheap,... Just ask my wife !!! But honestly I live in Northern Maine in the middle of Nowhere! We are so far out that we even send out for sunlight! But some may cost more to restore, and others are cheaper to restore. I totally disassemble them, replace worn parts that are needed, and repaint all parts first, then reassemble. The engine job cost me about $1000 to $1500 for parts and I do most of the machine work at home, some I send out (IE: Grinding Crank Shafts or special grind on cams) I can get one done in 200 hours of work. Bigger tractors take longer and I also can do just a paint job and repair a particular part.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Great Escape - by Dave Hollrah. It all began Monday with a little baling of second crop on the lake shore field, and as I drove out past my sister and her hubby's place, this small calling sound could be heard from the general direction of their manure pile. Out of the yard, over the cows and bale piles, through the dozer piles, poplars, and brush, out onto the ditch grade road, past the noisy 6.2 diesel engine pulling my well traveled Suburban along. Well it sure didn't take me long to figure out what it was because I alrea
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
