Farmall & IHC Tractors Discussion Board |
Re: Re: Re: M Duals??
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob M on October 27, 2002 at 17:53:36 from (24.169.120.138):
In Reply to: Re: Re: M Duals?? posted by mowner on October 27, 2002 at 17:35:43:
Sure - if your M has standard length axles you can mount a pair of the regular iron wheels on each axle. Just locate the inner set of wheels in as far as possible. We installed both the inner and outer wheels with the "dish" facing out, but you can install the inner pair with the dish facing in if you prefer. Running duals will not cause any harm to the engine/transmission/final drives. My Super M ran many thousands of hours pulling a plow and cultimucher on duals. You will want good brakes however - with duals you'll need the brakes more to make tight turns.
Follow Ups:
Home
| Forums
Today's Featured Article -
Check Your Coolant - by Bill Radford. Great tips on how and when to check the coolant in your tractor.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|