|
Farmall & IHC Tractors Discussion Board |
Re: New M
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dave_Id on October 30, 2002 at 11:49:50 from (67.250.102.28):
In Reply to: New M posted by Jeff w/an M on October 30, 2002 at 10:55:09:
There are loads of information in the archives... But painting is usually the last thing in a restoration just before final assembly... First you want to replace all leaky gaskets, seals, rebuild carb, tune it up, then depending on if you are painting for a work tractor, or for a show tractor will ultimately determine how much prep work you want to put in to it, from just pressure washing and paint over the 50 year old grease, to a total sandblast, and body putty every ding in the sheetmetal and a two stage urathane paint job... These are some things you have to decide on.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Day Tractor Lovers Dream About - by Angus Crawford. The day started at five o'clock on the morning of Friday, the January 29, 1999. My father, my sister, my uncle, my cousin and myself all climbed into my uncle's Toyota van. It was six thirty in the morning and we had a long day ahead. We traveled for six and a half hours to our destination - a little country town with a population of no more then one hundred and fifty people (57 of them being children under the age of thirteen). We arrived hoping to meet up with a man we knew had over one
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
