|
Farmall & IHC Tractors Discussion Board |
Re: f12 hyraulic pump gaskets
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by F14 on November 07, 2002 at 04:09:52 from (216.204.137.72):
In Reply to: f12 hyraulic pump gaskets posted by luke on November 06, 2002 at 18:37:45:
They're dead simple gaskets to make. I made ALL my own gaskets for the pump. In fact, except for the few that I got from NAPA for the engine (Valve cover, cylinder head, oil pan, crankshaft seals and couple others) I made all my own gaskets for the whole tractor. Not hard, and a good deal faster (and cheaper) than screwing around trying to find pre-mades. A set of gasket punches would be nice, but with a new blade in a utility knife and a little inventiveness, you can make your own. For instance, straight-wall pistol cases (such as a .38 or .45 caliber) make purdy good hole punches...
Follow Ups:
Home
| Forums
Today's Featured Article -
A Lifetime of David Brown - by Samuel Kennedy. I was born in 1950 and reared on my family’s 100 acre farm. It was a fairly typical Northern Ireland farm where the main enterprise was dairying but some pigs, poultry and sheep were also kept. Potatoes were grown for sale and oats were grown to be used for cattle and horse feeding. Up to about 1958 the dairy cows were fed hay with some turnips and after that grass silage was the main winter feed. That same year was the last in which flax was grown on the farm. Flax provided the fibre which w
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
