|
Farmall & IHC Tractors Discussion Board |
Re: Battery Charging idea
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob M on November 07, 2002 at 18:35:42 from (24.169.120.138):
In Reply to: Battery Charging idea posted by John (SC) on November 07, 2002 at 17:38:06:
John - Your idea will work fine! To simplify wiring, suggest wiring the quick disconnect with the hot side to the "BAT" terminal at the regulator. Then wire the grounded side to a regulator mounting screw. My old Kenworth truck had a similar setup when I bought it. The previous owner wired a quick disconnect to the hot side of the starter solenoid and to ground. A battery charger with a suitable mating fitting could simply be plugged in - no need to partially raise the cab (the truck's a cab over) and then wrestle the battery box cover off to charge the batteries.
Follow Ups:
Home
| Forums
Today's Featured Article -
When Push Comes to Shove - by Dave Patterson. When I was a “kid” (still am to a deree) about two I guess, my parents couldn’t find me one day. They were horrified (we lived by the railroad), my mother thought the worst: "He’s been run over by a train, he’s gone forever!" Where did they find me? Perched up on the seat of the tractor. I’d probably plowed about 3000 acres (in my head anyway) by the time they found me. This is where my love for tractors started and has only gotten worse in my tender 50 yrs on this “green planet”. I’m par
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
