|
Farmall & IHC Tractors Discussion Board |
Re: Re: Access to front transmission bearing seal....Super A
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jonathan Mirgon on November 09, 2002 at 09:43:58 from (216.29.223.63):
In Reply to: Re: Access to front transmission bearing seal....Super A posted by Haas on November 08, 2002 at 18:27:26:
haas, as it all correct ! just recently did mine, you mentioned that you were going to replace the bearing also, I would check the old bearing , and if there is no play in the shaft I would definetly leave it alone, this bearing is somewhat pressed onto the shaft and you will have a large amount of time and frustartion in replacing it, if its not bad I would let it go, I am restoring my 41 A and have replaced every seal and gasket on it, in doing this I didi not find one bad bearing, the bearings that they used back then will take alot more abuse than what they use today, I had to beat many of these bearings with a sledge hammer to get them off of shafts, and there was still no harm done to them. good luck,
Jonathan Mirgon
Follow Ups:
Home
| Forums
Today's Featured Article -
When Push Comes to Shove - by Dave Patterson. When I was a “kid” (still am to a deree) about two I guess, my parents couldn’t find me one day. They were horrified (we lived by the railroad), my mother thought the worst: "He’s been run over by a train, he’s gone forever!" Where did they find me? Perched up on the seat of the tractor. I’d probably plowed about 3000 acres (in my head anyway) by the time they found me. This is where my love for tractors started and has only gotten worse in my tender 50 yrs on this “green planet”. I’m par
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
