Re: RPM PTO speed on H

Posted by Hugh MacKay on November 11, 2002 at 15:10:14 from (64.228.11.143):

In Reply to: RPM PTO speed on H posted by Kelly C on November 11, 2002 at 04:59:14:

Kelly: That device Sam is talking about is a handy little item, designed to grip in that cone shaped hollow in end of PTO shaft, it told you the rpm of shaft. Measuring speed with no load, one should go for 575 to 600 rpm. I have one of these devices and most of the old Farmalls I checked years ago were not turning fast enough. You would probably find the factory setting on most C, H, M, 300, 400, etc. were very little over 540 with no load. IH did not put a lot empathizes on pto in those days, 90% of their market was in the Corn Belt.

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: RPM PTO speed on H Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]