Farmall & IHC Tractors Discussion Board |
Re: Rear axle seal on an A
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by gene b on November 18, 2002 at 03:35:55 from (63.15.134.180):
In Reply to: Rear axle seal on an A posted by Rich on November 17, 2002 at 12:16:52:
You must be talking about the short on the wheel bolts to. Take the inner cover off the one with the 4 cap screws take the nut off and also the lower pan and the axle will slide right out or at least it did last week on one that we replaced the outer seal. The outer cover next to the hub I removed with the axle. Mite need another pair of hands when putting together as the big gear has to be held while you slide the axle back in a verry greasy job but not the worst. glad to help gene b
Follow Ups:
Home
| Forums
Today's Featured Article -
Check Your Coolant - by Bill Radford. Great tips on how and when to check the coolant in your tractor.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|