|
Farmall & IHC Tractors Discussion Board |
Re: Re: Is it possible to reverse a magneto?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Chuck Hilton on November 22, 2002 at 09:54:02 from (205.188.209.78):
In Reply to: Re: Is it possible to reverse a magneto? posted by justin on November 22, 2002 at 07:20:31:
Yes a mag can be reversed. You will need to find the complete impulse for it though. Mag member you need is stamped L7 drive member is stamped L
These will give you the proper advance of 35 degrees for W9. The mounting flange can normally be modified by relocating the pin to the other side. You may need a letter R drill to do this. The point cam also needs to be turned opposite. Late mags are easier to turn point cam because they are not keyed. This is fresh on my mind because I am just completing the same thing. I just got hold of a I9 that mag was missing. I don't know where all these mags have gone but there must be some other folks that are confused about the opposite situation.
Chuck
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - Tractor Engine Repair - by Teri Burkholder. One of the great things about working on a tractor engine with your other half is that you know what he is thinking of at all times and can anticipate his every move and his next thought of what he will do. With Ben, anyway, I can tell! He'll be busy working and I’m handing him tools and he says, "give me that..." and I’ve already got it in his hand or "hand me that....."and I’ve got the portable light right where he needed it placed to see. "Run in the house and get me a...."as I open th
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
