Farmall & IHC Tractors Discussion Board |
convert cub to lowboy?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by orangeted on November 24, 2002 at 19:38:35 from (206.172.185.158):
I do not own any IH tractors myself but I have been looking at making the "ultimate" small mowing / snow plowing tractor. I was wondering if it is possible to convert a cub into a lowboy? --Is it possible to rotate the final drive 90 degrees thereby lowering the rear end?? I know this can be done with Allis Chalmers B's. On the same note is it possible to do this to an A, B or C? I think you could then fab your own front end to work with the old spindles and voila! A mowing tractor with more horsepower than the lowboy. Also what is the hp of the A B C. And how do their sizes and weights compare to the cub? thanks
Follow Ups:
Home
| Forums
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|