Farmall & IHC Tractors Discussion Board |
Re: Painting H Farmall
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by CNKS on November 25, 2002 at 19:46:37 from (207.178.96.214):
In Reply to: Painting H Farmall posted by Eddy (Tx.) on November 25, 2002 at 13:15:38:
To confuse you further: PPG Imron products: MP170 epoxy primer on both cast and sheet metal followed by MP 182 primer-surfacer on the sheet metal, followed by single stage acrylic urethane topcoat. Treat bare metal with Rass O Nil (Picklex 20, www.autobodystore.com/coatings.htm) rust converter. Cost including proper reducers and hardeners about $300. Additional cost for supplied air protection from isocyanates in hardener, about $500.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Day Tractor Lovers Dream About - by Angus Crawford. The day started at five o'clock on the morning of Friday, the January 29, 1999. My father, my sister, my uncle, my cousin and myself all climbed into my uncle's Toyota van. It was six thirty in the morning and we had a long day ahead. We traveled for six and a half hours to our destination - a little country town with a population of no more then one hundred and fifty people (57 of them being children under the age of thirteen). We arrived hoping to meet up with a man we knew had over one
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|