Re: International 1086 - information about TA

Posted by the tractor vet on December 07, 2002 at 20:08:11 from (216.196.12.82):

In Reply to: International 1086 - information about TA posted by Thomas Johansen on December 07, 2002 at 04:31:36:

You can do it yourself and they are not that hard to do , but there are some tricks to doing a good job that are not covered in a IT manual . A good T/A assy. will cost ya around 650 to 750 US funds plus shipping and a core charge will apply. then ya need a gasket kit and a MCV spring kit ( I recommend installing one ) and a new clutch and pressure plate new PTO input shaft and bearing pilot bearing and throw out bearing and since you are over there i would also install a new MCV hdy. pump just to cover all bases. And when you open it up you will probably find some other things that need replaced.

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: International 1086 - information about TA Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]