|
Farmall & IHC Tractors Discussion Board |
Re: M Farmall project
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Don LC on December 09, 2002 at 04:33:52 from (24.166.248.35):
In Reply to: M Farmall project posted by wolf on December 08, 2002 at 23:35:38:
Just a short time ago there was a M on here with a IH 345 cu v8 out of a truck....so we know that will work...realy looked sharp....he ran the exhaust up on each side,I would like to see them run down and back, with the hole in the hood filled......That is something I have always wanted to do.....I hand ideas of using a Ford 460 cu.....You could leave the engine stock,plenty of horse power......e-mail me with your ideas, I played around with engine swaps in cars and trucks for years.....I called them "sleepers"....
Follow Ups:
Home
| Forums
Today's Featured Article -
Product Review: Kreem Brand Fuel Tank Liner - by Staff. This condition has occurred on a few machines that we have had and fortunately we were able to borrow the technique used at the local motorcycle shop. The product that we have used is called Kreem thouh there are others on the market, this one was recommended and available. This particular product is sold in three parts, a bottle of etch, dryer, and sealer. We were fortunate enough to start the process with stern warnings from those that had used this type of product before. The horror
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
