Farmall & IHC Tractors Discussion Board |
Another Great Weekend Story
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Lary in CO on December 09, 2002 at 11:25:19 from (32.97.110.142):
I finally got the '46 H to the point that it was ready to start. It has been in the tear-down and rebuild/repaint stages for over a year now. This weekend I got it to the point that the wiring harness was done, the cooling system would hold water and got some gas in it. I turned the switch on and pressed the starter. It turned over half a dozen times with no luck. I pulled the choke and tried it again and IT STARTED!!! Boy talk about a sweet sound. The oil pressure came up to almost the top of the guage. I let her run till the water temp was up to the run mark on the guage and still had great oil pressure, even at idle. My thanks to to everyone who has ever posted on this board. Without all the great help and the archives, this would have never happened. Now all that is left to do is drain the rear-end and replace the axle gaskets and paint the rear wheels and rims. Larry
Follow Ups:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|