Farmall & IHC Tractors Discussion Board |
Re: Bottom Bearing Steering M
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jeff-OH on December 11, 2002 at 11:34:46 from (152.163.189.203):
In Reply to: Bottom Bearing Steering M posted by Duane Burgess on December 11, 2002 at 07:11:36:
Duane, I took the front bolster off my M last year and worked it over and bought new parts at my Case/IH dealer. I'll give you the numbers for those seals and the bearing plus a few others you may need. These numbers are out of my old M parts catalog but they can cross them over to the new ones at Case/IH dealer: Steering worm shaft oil seal-364 468 R91 Steering worm bushing-41 096 DBR Upper bolster bushing-45 172 DR Upper bolster pivot shaft oil seal-364 470 R91 Upper bolster pivot shaft thrust bearing- 354 675 R91 Upper bolster bottom bushing-49 661 DAR (this one is rough to get to) Even after I changed the pivot shaft oil seal, I still had a small amount of gear oil leaking down and ruining my new paintjob. So, I ended up pumping grease back into the steering gear housing like it was before I replaced all that stuff. Hope this helps.
Follow Ups:
Home
| Forums
Today's Featured Article -
Pitfalls of Tractor Engine Rebuilds - by Chris Pratt. The first pop after you have put the machine together with your own hands is exciting and pleasing. The whole experience can be marred if one moves too fast and makes too many assumptions that they can just use "as is" some parts they should be closely scrutinizing and possibly attended to. In such cases, rework makes what could have been a fun project turn into an irritant or even a nightmare. Minor Irritants To give you an example of an minor but irritating proble
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|